Two signal working mode:

Blue/purple LED, S-BUS signal , 10 channels totally.

Red LED, PPM signal, 10 channels totally.

Signal working modes switch:

Short press the binding button twice within 1 second to switch the S-BUS signal to PPM signal. When the Red indicator is on, signal output is PPM. When the Blue/purple led is on, signal output is SBUS.

Binding

1. Put the transmitter and the receiver close to each other within 50 centimeters.
2. Power on the transmitter and R6DSM. The RED led on R6DSM will start flashing slowly.

3. Switch on the transmitter and it will automatically bind to the closest receiver.

4. There is a black binding button on the side of receiver. Press the button for more than 1 second and release, the RED led will flash quickly, meaning binding process is ongoing.

5. When the RED led stops flashing and is always on, binding is complete.

6. Verify servos connected with the receiver can be operated by the transmitter.

Note Once upgraded with the latest firmware, the channel quantity of the transmitter(AT9/AT9S/AT9S PRO/AT10/AT10II) needs to be changed as10 to work with R6DSM, the 10 channel receiver

Press Mode button to enter BASIC MENU => Rotate the dial to select SYSTEM and Enter => Change CH-SELECT from 10CH to 12CH.

Note of Receiver Usage

1. Keep antennas as straight as possible to maximize the control range.

2. Big models may contain metal parts that influence signal emission. In this case, antennas should be positioned at both sides of the model to ensure the best signal status in all circumstances.

3. Antennas should be kept away from metal conductor and carbon fiber at least half inch away and no over bending.

4. Keep antennas away from motor, ESC or other possible interference sources.

5. Sponge or foam material is advised to use to prevent vibration when installing receiver.

6. Receiver contains some electronic components of high-precision. Be careful to avoid strong vibration and high temperature.

7. Special vibration-proof material for RC like foam or rubber cloth is used to pack to protect receiver. Keeping the receiver in a well sealed plastic bag can avoid humidity and dust, which would possibly make the receiver out of control.

When all the above steps are complete, please turn off the transmitter and repower on to test if the receiver is correctly connected with it.

Channels Qty:  10 channels

Operating Voltage: 4.8-6V